Testing Accessories

Browse our full catalogue of industrial testing accessories. Use the filters to narrow results by test type, sample standard, or force capacity.

138 items found

Newton Applications Software : N-ISO-178
Flexure
- Newton Applications Software
Analysis: Flexural Modulus calculated between 0.05% and 0.25% strain. DAQ: High-precision displacement.
Newton Applications Software : N-ISO-20482
Cupping
- Newton Applications Software
Analysis: Erichsen Cupping Index (depth at crack). DAQ: High-sensitivity Break Detection.
Newton Applications Software : N-ISO-20932-1
Cyclic
- Newton Applications Software
Analysis: Force decay and permanent deformation. DAQ: Time-based logging for Hold periods.
Newton Applications Software : N-ISO-3386-1/-2
Compression
- Newton Applications Software
Analysis: Compression Stress Value (CV). DAQ: High-resolution displacement for thickness measurement.
Newton Applications Software : N-ISO-34-1
Tear
- Newton Applications Software
Analysis: Median Tear Force (Trouser, Angle, or Crescent). DAQ: 100Hz to track the jagged tear peaks.
Newton Applications Software : N-ISO-4587
Shear
- Newton Applications Software
Analysis: Shear strength of rigid-to-rigid lap joints. DAQ: Peak capture at high frequency.
Newton Applications Software : N-ISO-527-1/-2
Tensile
- Newton Applications Software
Analysis: Tensile Modulus (Et) and Poisson’s Ratio. DAQ: High-resolution extensometer interface.
Newton Applications Software : N-ISO-6892-1
Tensile
- Newton Applications Software
Analysis: Lower Yield (ReL), Proof Strength (Rp), and Ag. DAQ: Synchronous Load/Strain at 50Hz+.
Newton Applications Software : N-ISO-8295
Friction
- Newton Applications Software
Analysis: Static (μs) and Kinetic (μk) coefficients. DAQ: 1kHz to capture the initial Stick-Slip spike.
Test Fixtures for AASHTO T285
Standards

Guided Bend Test (ASME IX).
Test Fixtures for ADIDAS ST-05
Standards

Extensometer Calibration.
Test Fixtures for AFERA 5001
Standards

Precision Peel Tables: Available in 90° and 180° configurations with low-friction bearings to ensure that measured force is purely adhesive…
Test Fixtures for AITM 1-0010
Standards

This Airbus Test Method determines the residual compressive strength of a composite laminate after it has sustained barely visible impact…
Test Fixtures for AITM 1-0076
Standards

Cyclic Fatigue (S-N Curve).
Test Fixtures for ANSI A118.1
Standards

Salt Spray (ASTM B117).
Test Fixtures for API 5L
Standards

DWTT (Drop Weight Tear).
Test Fixtures for AS 2205
Standards

Ferrite Scope Testing.
Test Fixtures for ASME IX
Standards

PQR Macro-Etch.
Test Fixtures for ASTM A185
Standards

Low-Carbon Tensile Specimen.
Test Fixtures for ASTM A262
Standards

ASTM A262 Practice A Etch.