ASTM D2990 Test Guide: Creep Testing for Plastics
CreepUtilize dual-redundant temperature sensors wrapped directly around the specimen gauge section to document micro-thermal gradients.
Testing Applications
Browse validated testing configurations. Filter by regulatory standard, material type, or force requirements.
7 items found
-
-
ASTM D3846 Test Guide: Shear Testing for Composites
ShearVerify that the machined notches pass exactly halfway through the specimen thickness to isolate a clean, center-plane shear field.
-
ASTM D6272 Test Guide: Flexural Testing for Plastics
FlexuralSet the support span precisely to standard depth configurations and verify loading noses are perfectly aligned at the third or…
-
ASTM D638 Test Guide: Tensile Testing for Plastics
TensileAlways measure real specimen cross-section thickness at 3 distinct points before clamping; do not rely on nominal molded values.
-
ASTM D695 Test Guide: Compression Testing for Plastics
CompressionAlways verify that the upper spherically seated platen is unlocked and free to float during alignment, then locked or allowed…
-
ASTM D732 Test Guide: Shear Testing for Plastics
ShearEnsure the center hole is drilled using a sharp, low-helix bit at slow feed rates to prevent micro-cracking and thermal…
-
ASTM D790 Test Guide: Flexural Testing for Plastics
FlexuralEnsure the support span is measured with a digital caliper and locked to exactly 16 times the measured thickness of…