ASTM B571 Test Guide: Peel Testing for Metals
PeelGrind the chisel edge to the exact specified angle and sharpen regularly to maintain uniform shear force application.
Testing Applications
Browse validated testing configurations. Filter by regulatory standard, material type, or force requirements.
14 items found
-
-
ASTM C364 Test Guide: Compression Testing for Composites
CompressionGrind the loaded ends of the sandwich panel flat and perpendicular to the facings within 0.02mm to eliminate edge stress…
-
ASTM C365 Test Guide: Compression Testing for Composites
CompressionAlways use a direct-contact deflectometer setup to measure core deflection; crosshead travel includes platen-seating errors.
-
ASTM D1000 Test Guide: Peel Testing for Tape
PeelAlways roll the tape onto the steel plate with a standardized mechanical roller at a uniform speed to eliminate manual…
-
ASTM D1621 Test Guide: Compression Testing for Foam
CompressionCut the foam blocks with a precision bandsaw or hot-wire setup to ensure the loading faces are perfectly flat and…
-
ASTM D2979 Test Guide: Peel Testing for Adhesives
PeelClean the stainless steel probe tip with reagent-grade toluene or isopropyl alcohol and a lint-free wipe before every single stroke.
-
ASTM D3330 Test Guide: Peel Testing for Tape
PeelMeticulously clean the stainless steel test plate with diacetone alcohol or n-heptane and a lint-free wipe before every single strip…
-
ASTM D3410 Test Guide: Compression Testing for Composites
CompressionAlways bond back-to-back strain gauges on every specimen to actively compute and document real-time out-of-plane bending percentages.
-
ASTM D3574 Test Guide: Compression Testing for Foam
CompressionAlways execute the three required structural pre-flex cycles to 75% deflection before recording official IFD force data.
-
ASTM D429 Test Guide: Peel Testing for Elastomers
PeelMeticulously document the exact failure mode split: R (Rubber Failure), RC (Rubber-Cement), CP (Cement-Primer), or M (Metal Interface).
-
ASTM D545 Test Guide: Compression Testing for Concrete
CompressionCoat the internal walls of the confinement fixture with a micro-thin layer of silicone grease or mineral oil to completely…
-
ASTM D575 Test Guide: Compression Testing for Elastomers
CompressionApply a thin, uniform layer of silicone oil or petroleum jelly to platens to minimize interfacial friction coefficients.
-
ASTM D695 Test Guide: Compression Testing for Plastics
CompressionAlways verify that the upper spherically seated platen is unlocked and free to float during alignment, then locked or allowed…
-
ASTM D903 Test Guide: Peel Testing for Adhesives
PeelAlways discard the first 25mm of peeling data from calculations; adhesive failure must reach steady-state equilibrium before capturing valid averages.