ASTM B571 Test Guide: Peel Testing for Metals
PeelGrind the chisel edge to the exact specified angle and sharpen regularly to maintain uniform shear force application.
Testing Applications
Browse validated testing configurations. Filter by regulatory standard, material type, or force requirements.
8 items found
-
-
ASTM D1000 Test Guide: Peel Testing for Tape
PeelAlways roll the tape onto the steel plate with a standardized mechanical roller at a uniform speed to eliminate manual…
-
ASTM D2979 Test Guide: Peel Testing for Adhesives
PeelClean the stainless steel probe tip with reagent-grade toluene or isopropyl alcohol and a lint-free wipe before every single stroke.
-
ASTM D3330 Test Guide: Peel Testing for Tape
PeelMeticulously clean the stainless steel test plate with diacetone alcohol or n-heptane and a lint-free wipe before every single strip…
-
ASTM D429 Test Guide: Peel Testing for Elastomers
PeelMeticulously document the exact failure mode split: R (Rubber Failure), RC (Rubber-Cement), CP (Cement-Primer), or M (Metal Interface).
-
ASTM D7791 Test Guide: Fatigue Testing for Plastics
FatigueAlways adjust the cyclic frequency downward if the infrared sensor tracks a surface temperature increase exceeding 2°C over the ambient…
-
ASTM D903 Test Guide: Peel Testing for Adhesives
PeelAlways discard the first 25mm of peeling data from calculations; adhesive failure must reach steady-state equilibrium before capturing valid averages.
-
ASTM E466 Test Guide: Fatigue Testing for Metals
FatigueThe active gauge area must be polished longitudinally to a mirror finish (down to 0.2-micron roughness) to eliminate circumferential machining…