ASTM B571 Test Guide: Peel Testing for Metals
PeelGrind the chisel edge to the exact specified angle and sharpen regularly to maintain uniform shear force application.
Testing Applications
Browse validated testing configurations. Filter by regulatory standard, material type, or force requirements.
15 items found
-
-
ASTM C1161 Test Guide: Flexural Testing for Ceramics
FlexuralEnsure the support and loading rollers are free to rotate and articulate to completely eliminate parasitic twist stresses.
-
ASTM C393 Test Guide: Flexural Testing for Composites
FlexuralAlways place the specified elastomer pads between the anvils and the panel to spread out high localized line loads.
-
ASTM D1000 Test Guide: Peel Testing for Tape
PeelAlways roll the tape onto the steel plate with a standardized mechanical roller at a uniform speed to eliminate manual…
-
ASTM D229 Test Guide: Flexural Testing for Plastics
FlexuralAlways track and document sheet extrusion direction; test samples in both longitudinal and transverse axes to chart directional variation.
-
ASTM D2344 Test Guide: Shear Testing for Composites
FlexuralInspect specimens under a microscope post-test; you must verify that the failure was true interlaminar shear and not top-edge crushing.
-
ASTM D2979 Test Guide: Peel Testing for Adhesives
PeelClean the stainless steel probe tip with reagent-grade toluene or isopropyl alcohol and a lint-free wipe before every single stroke.
-
ASTM D3330 Test Guide: Peel Testing for Tape
PeelMeticulously clean the stainless steel test plate with diacetone alcohol or n-heptane and a lint-free wipe before every single strip…
-
ASTM D348 Test Guide: Testing for Plastics
FlexuralEnsure both ends of compression rods are machined perfectly flat and parallel to within 0.025mm to avoid localized end-brooming.
-
ASTM D429 Test Guide: Peel Testing for Elastomers
PeelMeticulously document the exact failure mode split: R (Rubber Failure), RC (Rubber-Cement), CP (Cement-Primer), or M (Metal Interface).
-
ASTM D6272 Test Guide: Flexural Testing for Plastics
FlexuralSet the support span precisely to standard depth configurations and verify loading noses are perfectly aligned at the third or…
-
ASTM D6415 Test Guide: Flexural Testing for Composites
FlexuralMeticulously measure the inner radius and thickness at the curved apex to ensure mathematical precision in out-of-plane stress conversions.
-
ASTM D7264 Test Guide: Flexural Testing for Composites
FlexuralNote that ASTM D7264 dictates a 32:1 span-to-thickness ratio, which is twice the 16:1 ratio specified by the plastics standard…
-
ASTM D790 Test Guide: Flexural Testing for Plastics
FlexuralEnsure the support span is measured with a digital caliper and locked to exactly 16 times the measured thickness of…
-
ASTM D903 Test Guide: Peel Testing for Adhesives
PeelAlways discard the first 25mm of peeling data from calculations; adhesive failure must reach steady-state equilibrium before capturing valid averages.